RiCON Uses Areas
Using for followings to reduce contraction faults of concrete.
- Prefabricated concrete products
- Wet and dry system sprayed concrete production
- Airport, apron and parking of concrete
- Concrete which is subjected to impact load
- Ground concrete
- Showroom floors
- Ceiling panels
- Frontgate
- Highway barriers
- Decorative concrete panel
- Concrete Tubes
Practice
Ideal measure is for 1 m3 concrete needs minimum one package (600 gr).
Uses Suggestions
DISPENSING : RiCON fiber should be ideally added to the batching plant. In case of site mixing, additional mixing time of 3 to 5 minutes (70 cycles) is necessary to ensure that the product is fully degraded and to ensure uniform fibre dispersion throughout the mix. If mixing is at the batching plant, fibre should be added first along with half of mixing water. After all the other ingredients have been added, including the remaining mixing water the concrete or mortar should be mixed for a further few minutes at full speed to ensure uniform fibre dispersion.
TOLLS-PRACTICE METHOD : When using RiCON, the standard procedures for placing, finishing, and curing concrete is not changed, the standard rules of good concreting practice, concerning production as well placing, are to be followed. Refer to relevant standards. Fresh concrete must be cured properly.
CLEANING OF TOOLS : Clean all tools and application equipment with water immediately after use. Hardened / cured material can only be mechanically removed.
Local Restrictions
Please note that as a result of specific local regulations the performance of this product may vary from country to country. Please consult the local Product Data Sheet for the exact description of the application fields.
